FL-K / F type magnetic powder clutch: flange input, hollow shaft output, hollow shaft support and housing rotation

FL-K / F type (flange input, hollow shaft output, hollow shaft support, housing rotation) magnetic powder clutch Installation requirements: 1. Can be installed by means of base or bracket. 2. Pay attention to distinguish the input and output shafts of the clutch during installation. 3. Pay attention to the correct position of the water inlet and water outlet when using water cooling. 4. When cooling as forced air, the cooling air pipe is connected to the two screw holes of the clutch / brake coil housing. 5. It is recommended to use an axial elastic coupling to connect. When a belt connection is necessary, it is recommended to use a bracket or other mechanism to separate it from the magnetic powder clutch to prevent the shaft end from receiving radial forces. 6. The magnetic powder should be prevented from getting wet, and it should be kept away from the oil tank and water tank during installation, but due to the certain heat generated by the clutch during normal operation.